Yuyao Carlead Auto Products Co., Ltd.                                                                                                            
CONTACT

    Yuyao Carlead Auto Products Co., Ltd. is specialized in developing and producing ignition coils, switches and relays for Automobile, Motorcycle, Marine, Lawn Mower, Racing and Snowmobile.

    Dirección: West Shunyu Road, Yangming Street, Yuyao, Ningbo, Provincia de Zhejiang, China

    Tel: +86-574-62797220

    E-mail: sales@karlead.com

    WEBSITE: https://www.karlead.com

Location:Home >

Procedimiento de solución de problemas para el fallo de la bobina de encendido

2013/10/5      Click:


The ignition coil mainly supplies ignition energy to the ignition system of the engine. The failure rate of the coil itself is very low, but the failure of the coil cannot be completely eliminated. When the ignition coil fails, the ignition energy of the engine is insufficient, which may cause the engine to idle and the operation is unstable. Deterioration and other failures.

The ignition coil troubleshooting process is as follows:


Step 1 :
Set the ignition switch to "ON"


Step 2:
Unplug the ignition coil connector on the harness and use a multimeter to check if there is a battery voltage of about 12V between the 3rd pin and the ground wire on the connector.
If yes, please continue to the next step; if no, please check the line.

 
Step 3:
Unplug the ignition coil connector on the harness and use a multimeter to check if the No. 1 pin on the connector and the 5# of the ECU are short-circuited or open.
If yes, please check the line and ECU; if no, proceed to the next step.

 
Step 4:
Unplug the ignition coil connector on the harness and use a multimeter to check if the 2nd pin on the connector and the 2# of the ECU are short-circuited or open.
If yes, please check the line and ECU; if no, proceed to the next step.

Step 5:
Check if the primary coil resistance of the sensor is about 0.9Ω.
If yes, proceed to the next step; if not, replace the ignition coil.


Step 6:
Check if the secondary winding resistance of the sensor is about 14.5kΩ.
If yes, proceed to the next step; if not, replace the ignition coil.

Step 7:
Use an oscilloscope to check if the secondary ignition waveform of the high voltage line of the ignition system is normal.


If yes then check other parts.



点火线圈电路图  ▼


www.karlead.com | SITEMAP | Copyright 2022 Yuyao Carlead Auto Products Co., Ltd.- All Rights Reserved | 浙ICP备11005712号-1

 

share

网络工商

+86-574-62797220